Eleaf iJust 3 Vape Pen Review

por phoebe guo en June 07, 2018

Today we will take a closer look at the Eleaf iJust 3 , a 24-mm-diameter protective pen-style vape kit. If you used an Eleaf device, you will know that most of their releases tend to be reliable and easy to use.  The iJust 3 also doesn’t fall into this category.

The mesh line with various colors makes its looking great. The fire button is a reasonable size, in a hexagonal design, on the back is where you’ll find the USB connector to charge the battery.  When charging you can use this device.

When pressing the button, there will be LED lights around, you will know the power range through the four colors of the lights, and it will be on in the situation of short circuit and charging. However, it is not easy to see in a strong light environment.

The pattern design on the top is similar with that of bottom. There is a radiating hole at the bottom and a standard 510 interface on the top. The electrode can be connected seamlessly with most atomizers.  At the same time, the IJUST3 also has an air intake slot for the atomizer .


The matching Sub ohm tank ‘s diameter is also 24mm, but the glass tank is a bulb style which will increase the liquid storage capacity of the atomizer. Furthermore, the atomizer also uses a push-pull injection cap, which is extremely easy to use.


The atomization core is the net- styled. Wires are installed on both sides to ensure the core heated consitently. The cotton can offer the enough vape juice at 0.15 ohm. With the three-direction large bottom intakes, the whole atomizer will not have the problem of excessive heat when inhaling.

The maximum output of the IJUST3 with a built-in 3000 mAh battery can reach 80W, which is fully match the power range of the atomization core. And the IJUST3 can also be used with many atomizer products on the market, even with a RDA. But as the battery slowly discharges this output is going to be reduced so you will notice a slight decrease in performance, especially when you run when the battery is less than 10%.


The IJUST3 has a very good performance in terms of ignition speed and output. As the upper picture shows, the effect of 0.7mm wire that has just reached 0.11 ohm. Even with a low-resistance RDA, the IJUST3 can be works well, and with a single-coil RDA or RTA, the battery life will be longer.

Feel free to leave a comment in the section below, you can do so anonymously. You can also follow us on Facebook for contests, sales alerts and other fun stuff!


Los comentarios deben ser aprobados antes de aparecer

Spin to win Spinner icon